My new Diseqc switch 8x1

[Mudasir 4K]

I had bought new solid branded diseqc switch 1.1 and replaced my old 4x1 switch

 

[Mudasir 4K]

My current setup

 

[SivaG]

does ur mpeg2 box supports 1.1 ?

 

[Mudasir 4K]

No, but I have have kept diseqc none in settings for all signals connected to Mpeg2 Stb & I am getting signal on this Mpeg2 Stb too along with mpeg4 Stb.

 

[Mudasir 4K]

My mpeg4 stb controls the diseqc switch and I have divided out put signals of diseqc switch into two one connecting main mpeg4 Stb & other mpeg2 receiver

 

[Mudasir 4K]

Both mpeg4 & mpeg2 Stb working simultaneously connecting diseqc switch 1.1 port 3

 

[Johny]

Dividing Diseq switch out is working perfectly with a "T" connector ? is it working for 2 mpeg-4 receiver also ?

 

[Mudasir 4K]

I have not tried with two mpeg4 receivers at same time but I think it will work as same as mpeg2 is working but we have to disable all diseqc switch options in second mpeg4 receiver for safety as diseqc switch may get damaged

 

[M.J.Sadiq]

I am using same model bro.. Good one.. I need to understand your signal split. I have a problem as mentioned in the below thread.

Link Removed

Could you help me on that? Reply there in that thread if you any method for that.


..

 

[Mudasir 4K]

Remember, if my mpeg4 stb is connected to diseqc switch (port 3 for abs) & I tune my mpeg2 Stb connected to (Asia sat 7 port 2) then I am getting no signal to this channel unless I tune my mpeg4 stb to port 2