Begin tuning by slowly moving the dish first to the east in one-degree increments(5mm to 10 mm)for a total of three degrees, then in the opposite direction (west) while monitoring the receiver's signal meter. Peak the signal to the highest scale at this point. Ideally, this should be done using an satellite finder ,these allow for a more precise adjustment thanks to their greater signal sensitivity.
Wait for 5 Seconds for results on u r preview screen while Reciever storing the signal on particular Transponder..the moves another 5 mm u r dish as above given instructions..
Lock the antenna azimuth adjustment on the mount once the signal level is maximized.
Perform the same procedure as above using the elevation adjustment, first up and then down for peaking. Lock the satellite dish elevation at the point of maximum signal reception.
Don`t forget fine tune the skew of LNB for optimal results..
Your dish should now be aligned and with good picture in screen. Look the picture quality
in other channels & Transponders also and if necessary repeat the adjustments again...
Best of luck for happy hunting.. :tup