Good News Sound music control option in d2h HD Box..

[Sumitk70]

Wow good option for sound lovers . We can set a sound / music level of a singel channel ... Up / down music...

Menu - setting - user setup - channel setting - password - 1234 - press blue button ...volume ...

 

[balugudidiot]

Wow good option for sound lovers . We can set a sound / music level of a singel channel ... Up / down music...

Menu - setting - user setup - channel setting - password - 1234 - press blue button ...volume ...

Box Model Number?

 

[Niel Kumar]

Box Model Number?

We set this in V7000 type models

 

[Sumitk70]

We set this in V7000 type models

V- 5004 HD ..

Box Model Number?

My box v 5004 HD.

 

[yashwanth05852]

@Niel Kumar bro mine also V7000 STB.
I am using this option from past two years.

 

[Niel Kumar]

@Niel Kumar bro mine also V7000 STB.
I am using this option from past two years.

Ya I too using from 2019 know about this

 

[balugudidiot]

My box v 5004 HD.

Wr is your Dish setup image bro?

 

[Sumitk70]

Dish set up give tomorrow morning 100% due to some reasons today not possible..

 

[Sumitk70]

Wr is your Dish setup image bro?

Images of my dish With Mono block LNB -- Location Gurgaon Sector 8 ( Haryana - India )

Demo - is tested before Using Monoblock LNB --

Screw Angle / Dish Position will Same During Using the Disque switch As 88. East/ It have been tested before Using Monoblock LNB - D2H/ FAT Box for my another room without Disque Switch .. Room 1 & Room 2.


NOTE If you convert to NSS6 - SES 8 then your box remote will not work, When channel will come then start , No signal option work as D2H

You can try at MPEG 2/4 FTA Box before set it..

If this condition come then Press 15 - 20 Second Menu button Continues to comes again on Dish satellite management

 

[balugudidiot]

Images of my dish With Mono block LNB -- Location Gurgaon Sector 8 ( Haryana - India )

Demo - is tested before Using Monoblock LNB --

Screw Angle / Dish Position will Same During Using the Disque switch As 88. East/ It have been tested before Using Monoblock LNB - D2H/ FAT Box for my another room without Disque Switch .. Room 1 & Room 2.


NOTE If you convert to NSS6 - SES 8 then your box remote will not work, When channel will come then start , No signal option work as D2H

You can try at MPEG 2/4 FTA Box before set it..

If this condition come then Press 15 - 20 Second Menu button Continues to comes again on Dish satellite management

I have antenna aligned to st2 with universal LNB(single)...y.day tried replacing with monoblock lnb,but i didn't get signal chacked diseqc1 to 4..