Tata Sky reset all

[amit2k]

Hello by mistake I pressed reset all in Tata Sky. Now the screen has stucked in manual setting. I need following information - Frequency, modulation, symbol rate and in LNB set up information for Tata Sky STB

 

[Bapun]

You do not need to change those value. Just press Next, next and continue. It will work like before. Changing or playing with those values will cause problems.

 

[amit2k]

Thanks a lot for replying but It's not happening. The screen is showing these frequencies. But not going ahead. Could you please share those values.

Thanks in advance

 

[Bapun]

Thanks a lot for replying but It's not happening. The screen is showing these frequencies. But not going ahead. Could you please share those values.

Thanks in advance

For that i have to screw my STB. So not possible. May be you can share an image of error you are getting so we can try to help further.

 

[boldy]

insat 15 paarameter select and next ,check signal bar window,signal show and locked,wait 10 sec ,screen show next and automatic service channel runing

 

[Subha_007]

Hello by mistake I pressed reset all in Tata Sky. Now the screen has stucked in manual setting. I need following information - Frequency, modulation, symbol rate and in LNB set up information for Tata Sky STB

I don't believe that anyone can do a master reset by 'mistake',as it asks for a confirmation information before proceeding further. Anyway if you haven't dislocated the dish or the LNB,the setup should go with breeze as you can click on next multiple times. And if it is not happening,you need an TS engineer to fix the same. Everything always can't be done by everyone, that's why we have some specialists in each field.
Hope this guidance helps you!

 

[amit2k]

Thank you so very much....